1.叉车司机“五不叉”的内容如下：

（1）货物重心超过货叉的载荷中心,使纵向稳定性降低时不叉.

（2）单叉偏载不叉.

（3）货物堆码不稳不叉.

（4）叉尖可能损坏货物时不叉.

（5）超重或重量不明不叉.

2.叉车在作业中的规定如下：

禁止叉车作业时用货叉顶货,拉货,禁止叉车超载.叉车禁止载人行驶,电并叉车禁止同时接通两个动作电路,库内和车内码放每垛高度不得超四盘,叉车在叉放易碎品、贵重品或装载不稳的货物时要用安全绳加固,必要时有专人扶护才能行驶.

1. The contents of "five no Forks" for forklift driver are as follows:

(1) the center of gravity of the cargo exceeds the load center of the fork, so that it will not fork when the longitudinal stability is reduced

(2) single fork is not forked under unbalanced load

(3) the stacking of goods is unstable

(4) do not fork when the fork tip may damage the goods

(5) it shall not fork if it is overweight or its weight is unknown

2. The regulations of forklift in operation are as follows:

It is forbidden to use forks to lift goods, pull goods and overload forklifts. It is forbidden to drive forklifts with people. It is forbidden to connect two action circuits at the same time for electric and forklifts. The stacking height of each stack in the warehouse and in the vehicle shall not exceed four plates. When forklifts fork fragile goods, valuables or unstable goods, they shall be reinforced with safety ropes. When necessary, they can only drive with special support